>> Ultrasonic Flow meter User Manual
1) Commonly used menus. M00 or M02 is for meter reading. M30~M33 is for unit selection.
M40 is for selecting damping factor, generally 5~10 sec. M60 is for correcting time and date.
M26 is for curing parameters.
2) To avoid signal reduction and improve anti-jamming ability, it is better to use the
customized signal cable from flow meter manufacturer.
3) The length of cables between converter and transducer should be as short as possible,
cannot exceed 200m.
4) The temperature and humidity of working environment should be in the range of technical
specifications. Avoid direct sunlight on LCD.
To Previous Page
Loading...
Need help?
General
