Tsunami F-3 - Filling Oil; Turn the Device on; off; Cleaning and Maintaining

5D - FILLING OIL
1 - REMOVE THE WAX ATOMIZER FROM ITS BASE
2 - ATTACHED THE OIL TANK INTO THAT SAME BASE
3 - ATTACH THE OIL TANK INTO YOUR BATTERY, ATOMIZER
SHOULD FIT TIGHTLY
4 - PLACE A VERY SMALL AMOUNT OF OIL DIRECTLY INTO
THE TANK
5 - BEGIN VAPING BY PRESSING AND HOLDING DOWN
THE POWER BUTTON WHILE INHALING, KEEP POWER
BUTTON PRESSED DOWN WHILE VAPING
12 13
5E - TURN THE DEVICE ON / OFF
1 - PRESS THE POWER ON AND OFF BUTTON FIVE TIMES
IN TWO SECONDS, THE F-3 UNIT WILL TURN ON,
REPEAT THE SAME STEPS TO TURN IT OFF
NOTE 1: VAPORIZATION MAY VARY DEPENDING ON THE
TYPE OF MATERIAL
6 - CLEANING AND MAINTAINING
1 - TURN OFF THE F-3 DEVICE BEFORE CLEANING
2 - REMOVE THE MOUTHPIECE AND EMPTY THE
CHAMBER COMPLETELY
3 - USE THE CLEANING BRUSH TO CLEAN THE HEATING
CHAMBER
POWER
BUTTON
PRESS
POWER
BUTTON 5
TIMES TO
TURN
ON/OFF
3 4
5
REATTACH
MOUTHPIECE