Tiny Audio C3
Remark: In “Aux-Out” mode, there will be no FM transmission to the
car stereo.
Receive signal from the In-Car DAB+ radio through FM
transmission:
--Select FM Transmitting Frequency (Auto Mode):
1. Press and hold “MENU” button to enter menu mode, use Tuning Knob to
search for “Aux IN/OUT Select” and confirm by short press “MENU” again.
Use Tuning Knob to select “Aux-IN” and confirm by short press “MENU”
button.
2. Press “TX/SCAN” button to show FM transmitting frequency (TX FREQ).
3. Then press and hold “TX/SCAN” button for 3 seconds to activate the
automatic scanning of a “vacant” transmission
frequency without
interference with other channels. The scanning process will take
20-30
seconds to scan the frequency
automatically with a flashing display of
“---.-MHZ” and stop at a “vacant” frequency.
4. After a “vacant” frequency is found, press “TX/SCAN” button again to
confirm and exit setting or it will automatically confirm and exit the setting
after 3 seconds. The selected “vacant” frequency (TX FREQ) will be shown
at the top of the blue bar, e.g. TX108.0MHz
5. Then tune your car FM radio system to match the selected “vacant”
frequency (TX FREQ) for transmission of the audio signal from TINY AUDIO
C3 to your car stereo audio system.
Remark: To enable FM transmitter, you have to set the device into
“Aux-IN” mode.
6
To Next Page
Loading...