TTC FIREBERD 6000A User Manual

crrJ1 o/l
FIMBERD 6000 Setup
ANSI T7.403 PRMs with the
4 M4OA Interface
Wm - Set up tbe F~6000 BERME connecting to tk nehmrk.
By oatinuoudypmnpmnng tbe applprtate soPhey, you willsciwl tbreugb tk menu untUpu dyour &misetting.
A (up- hey) is dto return to tkpmdow menu selection.
use tbeblEWsofikey to sciwlthgb tk options untuyou reacblMPSE?W (ZED !&& it is iUumiMtad). Tbmjbbw tbe
steps below:
MllE: Tbe MSI Tl.43 PRM Option must be insrclued h tk PtREBBRD 6000 toperfonn tbis &st.
I Part 1 - Interface Setup
Tlrnl
CONFIG
PaAME
CODE
INPUT
MORE
RESULT
m1
A
MODE
MORE
T1.403
rn
ANALYSIS MODE
Access the TIN1 interface.
Access the CONFIGURATION menu.
ScmU through the
list and set to ESP framing.
Scroll through the list until you reach the appropriate coding of
your circuit (e.g., BSZS or AMI).
ScmU through the list and set to DSXMON (wuming DSX
access).
See additional selections.
ScmU through the
list and set to LIV.
Scroll through the list and set to IMDG.
ResstheA (uparmwkey) onthekepiitorehlmtothe
Tlml main menu.
Access the MODE menu.
Press mke to access additional selections.
Receive/genernte PRMs.
Press~MBllwtbekqlpdtorehlmtothemPinmenu
Select COmoUs.
(continued m luck)
lTC Technical Support
1-800-638-2049
w6ooO-ANSI.TllCudl.ll3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English