TTC FIREBERD 6000A User Manual

FIREBE.. 6000 Setup
Out-of-Service Y.35 Testing
I Part 1 - Interface Setup
1 449V35 Access the 449V.35 interhce.
2 TYPE
Access
the DATA TYPB menu. Set to V35 or 306 ((see the note
below for an explvwion of the ditIerence).
2P A
Press the A (upmw key) on the keypad to return to the
449N35 main menu.
3 EMULAT
Access the EMULATION menu.
3a DTE Selea MB emuhtion.
3b A
m the A (upanow key) on the kqpd to return to the
449N35 main menu.
Set Ih (local loop) or RL (remote loop) on, depeoding on the
DCE you wvlt to loopback
5 MTER
Press ENlER on the keybud to return to the maio menu,
6 DATA
Scroll through the list and seled a data patlera. htHB: Bitber a
511 or 2047pattem is tmmnrendadfor data mtes khueen
2.4 kWs and256 kWs.
7 GEN CU( ~voUthroughthelistands~to~toree~clwkhthe
m.
8 TIMING MODE
ScmU through the list and set to SYNC.
9 ANALYSIS MODE Select CONIWUOUS.
10 lrlMn'R
press to illuminate both signal leads, seaing them to HIGH
NOTE: Tk &tion betmtw V.35 or 306 is dejbdmt upon tk timing to tbe circuit under W. Witb a Y.35 circuit, tk serid
chk tmmit ertsntd (SCE) timing leadis diulMsd, wh wltb a306 tbh lead is enabled Simibrpocsdures may kfouougd
fOIRS449andX.21 dntacan &sting (your&tion ofTtPE in Step 2 ruillc&nge).
TTC Technical Support
l-8OO-638-2O49
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English