TTC FIREBERD 6000A User Manual

Cad1 of1
I
Part 2 - Performing the Test
mm
J
1 Press RIWART to dear alarms and begin the test. Verify that:
A. FIREBERD 6000's PATI'ERN SYNC LED is illuminated (indicating a signal is present).
I Table 1 - Analysis Results
ERROR BIT ERRS Change in Logical Value of Bit
BER
Ratio of Number of Errored Bits to Receive Bits
PAT
SLIP
An Addition or Deletion of Bits
PBRPOEMANCE GERR-SEC Emred Seconds
TlME EA SEC Emred Analysis Seconds
SIGNAL Rev PREQ Receive Frequencj
GEN FREQ Generate Frequency
ALARM PAT UlSS Count of Pattern Losses
C-D CH.4 Cloc!dDafa Phase Changes
DAT LOSS
Count of
Data losses
CLK UlSS
Count of Clock losses
NOTE: Ifyou me receivinga hrge number ofenors, your received clock may be fe. Ifthe received clock is missing w unusable
(a
hrge number of C-D ChX cbrmges is & an indication), the FIRBLEW 6W Rd Clock option (option 6W4) enuhks
tbe Dm to extract a clock from the receiueddata. Tbis willenuhkyou to determine whether tbe transmisfion line w the clock is
tbe source of
errors. See the setup belorujbr using the RdClock Option:
I. Set ~~G MODE to RBCOVD (tbis enables tbe PIREBERD bWO to wcom timingfmm transitions in the incoming data).
2. Rw tbeMENUso~?kq andsdthgb the list andset to SYMlWFRh'Q.
NOTE: The Renwered Clock Option only operates up to rates of520 kbh.
lTC Technical Support d
1-800-638-2049
FB6000-V35/Cud1,1/3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English