TTC FIREBERD 6000A User Manual

c#r 1 ojz
FIREBERD 6000 Setup
DSOA Out-o f-sewice Testing
Tbe fdbwingpocedun outlines tmu to connect tk PLRBBGRD 6WO witb a 306784 intet$ace to tbe whmr.4 in & toperfonn
out-ofservice
aBRT aaEysis on aFOA circuits from OCU-DP accessjacks. Fkw Plaaw tbe entinpocedum BEFME stariing.
WARNZIW; - Set up tbe PLRBBBRD 6W0 dlBPORB connecting to tk nehuwk.
~y mtinuoudypmdng tk ajpvpriate sopkey, you dsd thgb tk menu untilyou reacb your &mi Wing.
A (up-amnu key) is usedto nhun to tbepmfous menu selecNa.
. Use tk HEWsopkey to sd tbrargb tk options untilyou raacb LWP SETUP (LBD beside it is iUuminatm9. Tbenfollow tbe
steps bebw:
I Part 1 - Interface Setup
DSONB
MODE
DSOA
RATE
A
m
A
rnP
LATCH
lYPE
A
MORE
Access the DSOA/B interface.
Access the DATA POIMAT menu.
Select a DSOA format
Scroll through the
list until you reach the appropriale data me
of your circuit (e.g.,
2,4,4.8,9.6, 19.2, or 56 Ws).
Press the A (up-arrow key) on the keypad twh to rehm to
the DSONB menu.
Select the
lMgllPACB CODING menu:
Select LNEAR to test the local DSU/CSU (if acm is at the
OCU-DP).
Select LPAR !a test the distaot DSU/CSU (if access is at the
OCU-DP).
Select BWOL to provide signals on the tip and ring leads (if
access is at the DSO-DP).
Press the A (up-mw key) on the kqpad to return to the
previous menu.
Access the LOOP SBLBCTlON menu.
Select
MTCHING LOOP codes
ScroU through the list and set to WAN.
Press the A (up-arrow key) on the keypad twh to return to
the DSOA/B menu.
See additional selections.
TTC Technical Suppoa
1-800-638-2049
FB6OOO-DSOA/Cud1.2~3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English