TTC FIREBERD 6000A User Manual

~20j2
FIREBERD 6000 Setup
DSOA Out-o f-Service Testing CCO~~.)
Tabk 1 lid tntpkmt~YLFIS R&FCrlTS tbat should be checked.
Table 1 - Analysis Results
E1111OR BIT ERRS
BER
PAT SUP
ALARM PAT LOSS
DAT LOSS
CLKm
rn LOSS
SIGNAL REC kREQ
CEN kREQ
RCV CODE
RCV BYrE
Change in b~$cal Value of Bit
Ratio of Number of
Emred Bits to Received Bits
An Addition or Deletion of Bits
Count of Patlern
losses
Count of Data losses
Count of Clock Losses
Count of Power losses
Receive Frequency
Generate Frequency
Reportable DDS
Code
Cumt Byte
L
Tabk 2 is a list of IMliRFAO? STWUS LWs. When illuminated each of tbe stahrs UDs mean tbe fouauing:
I Table 2 - Interface Status LEDs
CODE
ALM 1
Illuminates when the interface is conlipred to receive a DSOB signal at any rate or a DSOA
at 19.2 kb/s and the interface has synchronized to the appropriate fnming.
Illuminates when the interface has initiated an altermting loopback and is mei\inp the
correct loop code
byres interleaved with the test data.
Illuminates when the RX
jack is terminated and operating with bipolar signals.
TTC Technical Support
1-800-638-2049
FB6000-DSOA/Card2.2/3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English