TTC FIREBERD 6000A User Manual

FIREBERD do00 Setup
Tbefdbwingpmdw outlines bow to mnect tbe FIREB&RD 6000 mlb its intend RS-232 interfi to eitkr tbe modem,
DSU/CFQ or (Nx)aFU-DP for out-of-sarice stmigbt muay and rwpback BERT aa(vsis. Pitwe read tbe entiwpocerkrm BEFVt?E
starMng.
I Part 1 - Interface Setup
lNT232
EMULAT
DTE
ENTER
DATA
GEN CLK
TIMING MODE
ANALYSIS MODE
RTYDTR
Access the RS-232 data interface.
Access the BMULATION menu.
Select D1E emulation.
Press BhTER on the keypad to rehm to the main menu.
kk'
Scmll through the list and select a data pattern. NOYE: Eitkr
511 or2047pattem is recommmdedfor d& rates &men
2.4 kb/s and 64 kbh.
Scroll though the Ust and sd to IhTF to receive clock fmm the
DCE.
Scroll through the list and set to SYNC.
Select ComNuoUs.
Press to illuminate both slgnal leads, setting than to HIGH.
I
Part 2 - Performing the Test
1
Press IIBSIART to dear alarms and begin the test. Verify that:
A. PIREBERD 6000's PATIXIIN SYNC LED is isiUumated (indicating a signal is present)
(mrinued on back)
O 1997 Telecmunimions Techniques Corpontion. All rights reserved.
lTC Technical Support
1-800-638-2049
FB6OlW-RS232/Cudl.l/3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English