TTC FIREBERD 6000A User Manual

crrnl1of1
Table I lists inrpwfrmtAN4YLFS RBSULTS that sbouLI be checked
I Table I -Analysis Results
d
ERROR BIT ERRS Change in logical Value of Bit
BER
Ratio of
Number of Errored Bits to Receive Bits
PAT SLIP
An Addition or Deletion of Bits
PERFORMANCE
GERR-SEC Errored Seconds
TlMB
EA SIX Error Anatysls Seconds
SIGNAL
PREQ Receive Frequency
GEN PREQ Generate Frequencj
ALARM PAT UlSS Count of Panem Losses
C-D CHA Clock/Datl Phase Changes
DAT LOSS
Count of
Data losses
CLK UlSS
Count of
Clock Losses
NOTE: I~~Gu are recer'w'ng a knge number of mrs, your meiced clock ntay be faulty. gtbe recer'dclock is missing or unu&
(a knge number of C-D CM cbnges is also an indidion), tbe PIRh'&6RD 60W Recmd Clock Option (Option 6004) maMes
tbe DlE to extract a clockfmm tbe &d data. Tbis wiU enable you to determine wbetber the trrmrm- line or tbe clock is
tbe sourn of m. See the setup below for using tbe Recoveredclock Option:
d
1. Set TLHMG MODR to RBCoVD (tbis enables the PIREBERD 60W to mom' timingfrom tram'tions in tbe incoming data).
2. Presstbe~softkeyand~dtbrougbtkIistandsetto~~Q.
3. Using tbe keypad, enenter tbe expected recelce~uencyuency Press tbeEM73R key to s&t tbisfrequsm.
NOTE: Tbe Recovered Clock Option o@y ojkmtes up to rates of 520 kWs.
lTC Technical Support
1-800-638-2049
J
FB6000-RS232/Cudl.l/3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English