TTC FIREBERD 6000A User Manual

Part 2 - Performing the Test
,
1
Press RESTART to clear alarms and begin the test. Venfy that:
A. mREBERD 6000's PAITERN SYNC LF.D is illuminated (indicating a signal is present).
B. F'IREBERD 6000's PRM SYNC LED is illuminated (if PRM SYNC is not illuminated, go back to Step 2a and select
the appropriate frame format).
Table I lists intportantMYLSIS RBSm tbal sboull be cbecw.
I Table 7 - Analysis Results
T-CARRIBR BWs
FRA ERR
CRC ERR
FRA LOSS
BIT SLIP
SIGNAL +LVL dB
-LVL dB
PP LVL v
RCV FREQ
Bipolar Violalions
Frame Emors
CRC Ermn (ESF framing only)
Frame
Loss
Bit Slips (applicable only with a REFCl)
Positive Receive Signal
level
Negative Receive Signal Level
Peak-to-Peak Receive Signal level (volts)
Receive Frequenrj
I
Table 2 - Interface Status LEDs
CODE
ALM 1
ALM 2
Illuminates when B8ZS cading is being received.
Illuminates when a Yellow Alarm is detected.
Illuminates when an Excess Zeros Alarm is detected.
0 1997 Teleeommunicltions Technique Corpontion. All rights mewed.
lTC Technical Support d
1-800-638-2049
FB6000Full.Tl/Cardl.lI3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English