Battery Precautions
¥ Blue-Bot is powered by a DC 3.7V 500mAh Lithium Polymer rechargable battery.
¥ Rechargeable batteries are only to be charged under adult supervision.
¥ The supply terminals are not to be short-circuited.
¥ Regularly examine for damage to the plug, enclosure and other parts. In the event of
any damage, the toy and charger must not be used until the damage has been
repaired.
¥ Exhausted batteries are to be removed from the product.
Care & Maintenance
¥ If necessary, wipe Blue-Bot gently with a clean damp cloth.
¥ Keep Blue-Bot away from direct sunlight and heat.
¥ Do not allow Blue-Bot to come into contact with water or other liquids. If painting or
gluing on the additional shells, ensure the shells are dry before clipping to Blue-Bot.
¥ In the event of a static discharge, Blue-Bot may malfunction. In this case, please
switch it off and then back on again to reset it.
Important Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
To Next Page
Loading...