TUBES EVE - Operating Instructions; Switching On; Operating Modes; Heating Mode Details

13
EN
cod. MAN#EVE - Luglio/July 2019
OPERATING INSTRUCTIONS
TOUCH controls
Mains
Connecon Plug
Key/Led ON/OFF
Key/Led MODE
SWITCHING ON
To use Eve, you must first connect the
power cord to the electrical socket
using the plug supplied.
Two keys on the body of the Eve radia-
tor, acng as indicator LEDs as well as
touch controls, show when the device
is switched on or off.
Only when rst switched on, Eve
automacally performs the set-up and
the two LEDs emit WHITE light for 10
seconds. Eve then goes into Stand-by
mode and the user can select the desi-
red operang mode.
When switched on subsequently,
Eve will already be set up and the two
LEDs will emit WHITE light only for 2
seconds. In this case too, Eve then goes
into Stand-by mode and the user can
select the desired operang mode.
Stand-by mode is indicated when the
ON/OFF control ,lights up, turning
RED, and the MODE control , con-
trol switches off, followed by a beep.
OPERATING MODE
Make sure that the device is in Stand-by
mode. The operang modes can be se-
lected using the two keys on the body
of Eve that act as touch controls, as well
as indicator LEDs.
To turn on the desired control, simply
lightly touch the icon corresponding to
that control with your finger.
Do not press.
• LIGHTING Mode
Lighng provides for a dimmable light
emied from the lower vent of the
body. It is turned on using the following
procedure:
Touch the ON/OFF control for 3
seconds: : the LED will remain WHITE
but the device will emit a beep and the
light will come on.
Touch the ON/OFF control again for
3 seconds: the LED will remain WHITE
but the device will emit another beep
and the light will go off.
To regulate the brightness of the dim-
mable light, keep pressing the MODE
control for at least 6 seconds unl
the light begins to vary its brightness.
The light will alternate between dim-
med and bright phases unl the control
is released at the desired level.
• HEATING Mode
Heang involves emission of a heat
through the openings in the structure,
adjusted according to two different
power levels. It is turned on using the
following procedure:
• Touch the MODE control for 1
second: the LED turns ORANGE and the
device emits a high power ow of hot
air (about 800W);
• Touch the MODE control for 1
second: the LED turns GREEN and the
device emits a low power ow of hot
air (about 400W);
• Touch the MODE control for 1
second: the LED turns ORANGE again.
If you connue to click on the MODE