TUBES EVE - Advanced App Features; Identify Device; Reset Procedure; Troubleshooting and Maintenance

17
EN
cod. MAN#EVE - Luglio/July 2019
the extra features icon at top right and
select “Open Window”.
• Idenfy Device
NB: this can only be used via the
TUBES Plug&Play App.
This feature allows you to locate a devi-
ce when lost or to idenfy a specific de-
vice when it is placed in a room where
there is more than one device remotely
programmed via the TUBES Plug&Play
app.
By enabling this feature, the device can
be recognised because it emits 4 beeps
and the two LEDs ash simultaneously.
To use this feature with the app, click
the extra features icon at top right and
select “Idenfy Device”.
RESET
This procedure resets the temperature,
weekly programming, open window
detecon and metering of the minutes
before changing the filter to the default
sengs. Addionally, the Wi-Fi sengs
are reset (procedure required if you
want to connect the device to a diffe-
rent network).
To reset the device to factory sengs,
you must unplug it and plug it back in
again. Immediately aer plugging it
back in again, as soon as the two LEDs
light up, touch both touch controls at
the same me for at least 10 seconds.
You will then hear 5 beeps, signalling
that the reset procedure has begun.
(This is the same procedure as the one
performed to enable/disable Wi-Fi con-
necon; however, you need to ignore
the beep you will hear aer 5 seconds,
and keep touching the controls for at
least 10 seconds.)
During the reset, both the MODE and
the ON/OFF controls controls emit
- alternang - a WHITE FLASHING light.
When the reset has ended, a single
beep signals that the operaon has
been completed.
NB: to reset the seng, the Eve Wi-Fi
must be turned on. If the Wi-Fi is not
turned on, it will not be possible to reset
Eve.
MALFUNCTIONS
In the event of malfuncons, the touch
control LEDs will ash. The following
malfuncons are possible:
Overturn Alarm
If the device is accidentally knocked
over and overturned, venlaon and
heang are temporarily turned off. The
MODE control signals the anomaly
with a FLASHING WHITE light.
When it is returned to the correct posi-
on, the device goes back to the mode
in which it was operang before being
overturned.
NTC Alarm
If the device detects a temperature pro-
be malfuncon, heang is temporarily
turned off. Venlaon on the contrary
remains on for two minutes and then
the top is automacally lowered and
the device switches off.
The two LEDs emit synchronised FLA-
SHING DARK RED lights. This alarm
indicates a temperature probe malfun-
con. Please contact the Tubes Techni-
cal Service.
MAINTENANCE ADVICE
Before carrying out any maintenance,
switch off the appliance. The choice of
the best materials and the quality of
the double surface treatment protect
the Tubes radiator against corrosion
and impact. Simple maintenance ensu-
res long life of the appliance. The fol-
lowing suggesons are recommended:
• Clean the outside walls of the radia-
tor, preferably using a damp cloth.