Care and Maintenance Instructions
Cleaning the Filter Cartridge
1. Disconnect power
2. Remove the filter cover
3. Unthread the Filter Cartridge counter clockwise
4. Rinse dirt and debris away thoroughly with a garden hose
5. Replace filter cartridge and cover
6. Reconnect power
Replacement Filter Cartridge Part Numbers
-150, 350 Models – Unicel 4CH-20, Pleatco PSG25P4, or Filbur FC-0125
-250, 450, 650 Models – Unicel 5CH-402, Pleatco PJW40SC-F2M, or Filbur FC-2811
Water Chemistry
Read and understand the spa chemistry guidelines supplied by your dealer or local chemical
supplier. There are many solutions available to balance your water chemistry. If you are unfamiliar
with water chemistry, your best option is to work with your dealer or your local chemical supplier.
It is unhealthy to use your spa when the water is not in proper chemical balance.
Warning:
Do not use Calcium Hypochlorites or Trichlors. Doing so may cause corrosion to your pump and
possibly fade your spa surface. This will not be covered under the warranty.
Minimum Weekly Maintenance
1. Test water for chlorine and pH
2. Adjust pH to 7.2-7.8
3. Adjust chlorine to 1-3ppm
Winterizing
If the Spa is to be transported or stored in temperatures 32º F (0º C) or lower, it is critical that the
spa be fully winterized. For specific, regional winterization guides, please contact your local
dealer. Below are general guidelines:
1. The spa must be completely free of water
2. The drain valve must remain in the open position
3. The drain valve cap must be removed and stored
4. The filter cartridge element must be removed, dried and stored
5. Remove the plug from the pump housing
To Next Page
Loading...