Slip Clutch adjustments
Slip Clutch must be adjusted before rst use or aer a storage period.
1. Using a marker, scribe a line across the exposed edges of the clutch plate and friction discs.
2. Back off compression nuts to free friction discs by turning each nut exactly 2 revolutions.
3. Start the tractor and run the driveline at a low idle to slip the friction discs. This will remove the
dirt, corrosion and surface oss from the clutch plate faces.
4. Disengage PTO, shut down tractor and wait for all components to come to a complete stop.
5. Inspect the clutch and ensure that the scribed markings on the disc and plates have changed po-
sition. If any two marks are still aligned, this is an indication that these discs have not slipped. It may
be necessary to completely disassemble the clutch to free them up.
6. After ensuring all discs are free, tighten the compression nuts, uniformly, exactly 2 revolutions
to reset the clutch at its original pressure, where the springs are 1 1/4” compressed length.”
Working Depth Adjustment
The working depth is controlled by raising or lowering the side skids.
If the skids are raised the working depth increases.
By lowering the skids the tilling depth with decrease.
Tailgate adjustment
The tailgate can be adjusted to help smooth
and compact the tilled ground. Release the chain and secure to the
desired height.
Start up
After making the necessary adjustments, lower the rotary tiller until
the blades are a couple of inches from the ground.
Engage the PTO and slowly lower the tiller to begin working.
Removal and Storage
After nishing, remove the rotary tiller from the tractor.
1. Put the PTO driveline in a safe location so it will not become damaged.
2. Clean and dry the equipment.
3. Replace any damaged or worn parts.
4. Check all bolts and nuts for tightness.
5. Lubricate and protect the machine from the elements.
9 Operations
Caution: Slip Clutches may become hot. Do Not Touch. Keep the slip
clutch area clear of any material that may catch re. Slip clutches
have adjustable torque settings. The torque setting varies with the
different compression of each spring. All the springs should have an
equal amount of compression.
IMPORTANT: Do not over-tighten the compression nuts as this may
impair performance or cause premature wearing of the slip clutch.
To Next Page
Loading...