FOLLOWING OPERATION
• Following operation, or when unhitching, stop the tractor or towing vehicle, set the brakes, disen-
gage the PTO and all power drives, shut off the engine and remove the ignition keys.
• Store the unit in an area away from human activity.
• Do not park equipment where it will be exposed to livestock for long periods of time. Damage and
livestock injury could result.
• Do not permit children to play on or around the stored unit.
• Make sure all parked machines are on a hard, level surface and engage all safety devices.
• Wheel chocks may be needed to prevent unit from rolling.
PERFORMING MAINTENANCE
• Good maintenance is your responsibility. Poor maintenance is an invitation to trouble.
• Make sure there is plenty of ventilation. Never operate the engine of the towing vehicle in a closed
building. The exhaust fumes may cause asphyxiation.
• Be certain all moving parts on attachments have come to a complete stop before attempting to
perform maintenance.
• Always use the proper tools or equipment for the job at hand.
• Use extreme caution when making adjustments.
• Never replace hex bolts with less than grade ve bolts unless otherwise specied.
• After servicing be sure all tools, parts and service equipment are removed.
• Where replacement parts are necessary for periodic maintenance and servicing, genuine factory
replacement parts must be used to restore your equipment to original specications. The man-
ufacturer will not claim responsibility for use of unapproved parts and/or accessories and other
damages as a result of their use.
• If equipment has been altered in any way from original design, the manufacturer does not accept
any liability for injury or warranty.
MAINTENANCE
8 hours Grease the Rotor support (GP grease)
Grease PTO shaft cross & bearings (GP grease)
Check Hardware for tightness
16 hours Check oil level in center gearbox (90wt)
Check oil level in side gearbox (140wt)
Check Hardware for tightness
200 hours Replace oil in center gearbox (90wt)
Replace oil in side gearbox (140wt)
Check Hardware for tightness
Replaceing Blades
In order for the tiller to perform optimally, make sure the tiller blades are in good working condition and their
bolts and nuts are tight. Always replace the blades with the bolt head against the blade and the washer and nut
on the ange side to help prevent the blades from loosening.
Following Operations/ Maintenance 10
To Next Page
Loading...