Installation Guide
Double Roller Blinds
Before you begin
The front roller blind is the highest and closest to you, so make sure
that when marking the place where you will place the brackets, the
rounded part of the bracket is pointing downwards.
Front
Blind
Rear
Blind
Fitting the brackets
The brackets offer three methods of installation:
Top-Fixing
Where the brackets are
screwed into the lintel (or
‘ceiling’ of the recess)
Face-Fixing
Where the brackets screw
into a facing surface (a
wall or window frame)
Side-Fixing
Where the brackets are
screwed into the side
walls of the recess
Top Tip
Top-fixing or face-fixing are
recommended for most
installations, whereas
side-fixing is only
recommended if the width you
gave us was taken right at the
top of the recess.
If you upgraded to our Twist2Fit system, skip to page 3.
Page 1 of 6
On the control side, clip the chain runner attachment
into the slot in the centre of the bracket (not required
for SmartView Blinds). On the opposite side, clip the
circular tabs into the cross sections of the bracket.
Control Side
To Next Page
Need help?
General
