TUISS SmartView - Page 2

Front blind
(reverse roll)
Back blind
(standard roll)
Fitting a standard or SmartView Double Roller Blind
Installation Guide
Double Roller Blinds
Install the rear blind first. Begin by placing the
spring-loaded pin into the lower cross-shaped
hole on the bracket. Push the blind toward the
bracket so the spring-loaded pin depresses.
Keeping the pin depressed, lift the sidewinder
end of the blind upwards so the blind is level
and the chain is hanging directly down from
the bottom of the sidewinder and slot the pegs
of the control into the cross section of the
bracket.
Repeat the process for the front blind, placing
the pin into the cross-shaped hole on the
bracket and lifting the sidewinder side up to
slot into the cross section.
4
3
1 2
Page 2 of 6
Take the chain for the top (front) blind and
drape the back part of the chain over the chain
runner so that the chain sits forward,
preventing it from tangling with the other
blind’s chain.
(Not applicable for SmartView Blinds)
Front
blind
Rear
blind