Fitting a Double Twist2Fit Roller Blind
Installation Guide
Double Roller Blinds
Front blind
(reverse roll)
Back blind
(standard roll)
Top Tip
Make sure that you tighten the wheel as much as you possibly can so that the blind remains secure and does not slip. If you find
that the ‘foot’ of the mechanism that presses against the wall is spinning as you try to tighten, take the blind out of the window,
tighten it a little, then push it back into place and try again. However, avoid over-tightening, as it could lead to breakage.
Tightener on the rightTightener on the left
Hold the blind securely in place and turn the
tightening wheel to tighten the blind in place.
If the tightener is on the left side of the blind turn it
towards you. If it’s on the right, turn it away from you.
For smaller blinds:
Page 3 of 6
Starting with the blockout (front) blind, insert the blind into the recess at an angle and push the tightener against the wall. Lift the
control end of the blind until level and release pressure, the blind will hold itself in place. The front blind can be fitted close to the
front of the recess, right at the top.
Make adjustments to the position of the blind so that it is straight and level, before locking it in place.
To Next Page
Loading...