To Next PageTo Next Page
Need help?Do you have a question about the Tulikivi HETTA and is the answer not in the manual?
Tulikivi Lightweight fireplace may only be installed by an authorized Tulikivi installer. Installation must comply with local regulations.
Use only dry firewood. The moisture content of dry wood is 15-20%. All wood species and wood-based briquettes are suitable fuel.
Start firing as advised. The protective varnish of the fireplace insert hardens during the first heating. Odors may occur, so ensure that the room is properly ventilated.
Start the heating of the fireplace by placing dry kindling on top of firestarters. Light the firestarters and close the door.
Covers ash box emptying, draft checking, and general firing procedures for regular operation.
Clean the door glass with glass cleaning fluid or ash and moistened kitchen paper towels. Clean only when cold.
The soapstone surface can be washed with ordinary household cleansers. Use stain remover for tough stains on smooth surfaces.
Small fractures in panels do not affect function, but a panel must be changed if broken or badly chipped.
Creosote buildup from slow burning needs inspection and removal to reduce chimney fire risk.
Instructions on operating the start-up and primary air control levers for optimal combustion.
Warning about house fires if not properly installed. Do not use flammable liquids to start fires. Keep combustibles away.
Specifies minimum distances to combustibles for standard residential installation (singlewall connector).
General