Tumbl Trak Boundex - Assembly Process; Prepare the Lycra Bed; Insert Support Bars; Attach Upright Legs

STEP 1 – Lay the yellow Lycra bed out at and locate the four openings at
each corner.
STEP 3 – It is easiest to begin aaching the rst leg by laying it on the ground.
Make sure the D2 knobs are facing down. Aach the rst leg by inserng the
support bar end into the coinciding leg side.
STEP 3 (A) — To insert the other bar, li up the leg making sure the hole and D2
knob is aligned to successfully lock into place.
Step 1
Step 3
Step 3
Step 2
STEP 2 — Feed one foam covered support bar through each sleeve of the Lycra bed, forming the square for
the top of the Boundex. STEP 2 (A) — Make sure each bar is facing outward.
Step 2 A
Step 2
STEP 4— While sliding the upright legs into the support bars, make sure to pull
the knobs outward at rst unl the bar slides past the knob, then release and
adjust unl you hear an audible click, indicang the knob is in place.
Then, ghten the knobs securely.
Step 3 (A)
Step 4
Any questions or problems, please call Tumbl Trak at (800) 331-4362