110 111
“wavecontroller“ – oscillating current with the Wavebox (1)
If enabled, the “night mode“ function will interrupt the Wavecontroller when the aquarium lighting is switched off, the
Wavebox remains off. In the morning, after the light turns on again, the oscillating ow will also restart.
Further options:
The “wavecontroller“ function can be combined with each “mode“ setting. The calculated resonance frequency can be
entered in “pulse ow“, the congured circulation pumps will then support the oscillating current ow in the aquarium.
“wavecontroller“ – oscillating current using only the Turbelle
®
pumps (2)
The Wavecontroller function can also be used for Turbelle
®
propeller pumps without the Wavebox. However, we
recommend to always use at least two Turbelle
®
stream positioned adjacently. For this, the “inverse” function should
be clicked.
Settings: see “wavecontroller“ - oscillating current with the Wavebox
To Next Page
Loading...
