Installation Instructions / Notes and Warnings
Protect the device from direct exposure to sunlight.
Do not position the device near or directly in contact with sources of heat or
electromagnetic fields.
Connect the device to power lines other than those for operating motors or
other large power devices which could generate network interference.
Fix the device of a height of at least 60 cm from the ground.
Check that atmospheric conditions are safe before starting any operation on
the device.
For electric operations, always remove voltage, wait 30 seconds for the
inside capacitors to discharge before opening. At the end of the operations,
close the device to restore the correct degree of protection before powering
up.
Use flame-retardant cables with a minimum cross-section area of 0.25 mm2
for all control signals.
Use flame-retardant cables with a minimum cross-section area of 0.75mm²
to connect to the power supply.
Use flame-retardant cables with a minimum cross-section area of 1.5 mm2 to
connect to the indicating relays.
Any use not described in this user instruction manual or incorrect use of the
device may cause damage to the device or to the devices connected to it.
Furthermore, incorrect use or tampering with the device may cause injury.
Waterproofness of the casing is guaranteed when the flap is closed.
Make sure that rigid or flexible ducts used for wiring, if any, do not fill up
with water or other liquids.
Any holes made in the casing must be protected by accessories with degree
of protection equal to at least that of the sequencer.
Cut off power supply immediately if water is found in the casing.
Do not use the sequencer if you have not read or do not understand this manual.
To Next Page
Loading...