user manual
FLEX ARRAY
FLEX ARRAY user manual
Page 24
There are two methods of defining an audience area. In either case you must define the
X1/Y1 coordinate of the start of the area; you can then either enter the X2/Y2 points or its
length and angle.
As you create audience areas they are shown graphically in the main window.
Desiging the Loudspeaker Array
The next step is to design the loudspeaker array using the “System Setup” window. Select
the “System Setup” tab in the bottom left of the screen and begin by choosing the desired
flybar or ground stack in the drop down box at the top left of the window.
Now select the number of cabinets deep that you wish to hang or stack from the “Box Count”
drop-down menu. Trim height or PA wing height can now be set in the “Position” field.
If a mix of Low and High cabinets are to be used then select in the “Cabinet” window the
type and location in the array of each box. The angle between cabinets can now be set in the
“Angle” list. Each cabinet has an aiming line that can be used to determine the centre of each
cabinet‟s dispersion. Adjust the trim height, top angle and inter-cabinet angle to achieve
optimum coverage.
To Next Page
Loading...
Need help?
General
