8 TFM Series Quick Start Guide 9
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information about this or any other product, please visit
our website at turbosound.com.
Unpacking the Loudspeaker
After unpacking the unit, please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future returnshipment.
System Requirements
The TFM122M and TFM152M models are switchable passive / bi-amp 2-way loudspeakers.
Passive operation (full range or with a subwoofer) requires 1 ampli er channel and 1 controller channel. The input signal is divided between the low-frequency and
high-frequency drivers internally with a passive crossover. Bi-amp operation (full range or with a subwoofer) requires 2 ampli er channels and 2 controller channels,
one for low frequencies one for high frequencies. The input signal is divided between the low frequency and high frequency driver in the controller and the individual
ampli ed signals are fed to the speaker input.
Correct controller settings for all models operation and subwoofers can be downloaded from turbosound.com, and are also available as presents for LAB GRUPPEN
ampli ers, and for LAKE LM processors. To avoid wasting ampli er power, you should use heavy-duty speaker cable with a minimum wire size of 1.5 mm (16 AWG),
and preferably 2.5 mm (14 AWG) for longer runs. For extreme cable lengths, be aware of cable impedance and resistive losses. Always observe the correct polarity.
1. ឱ឵ᤉឮǎ
2. ឱݱؔεߜᤉឮǎ
3. ឱญధᄋᇩǎ
4. ឱᥗ߷ధᄋឮǎ
5. ឱӉڛ᭦ᤄබᄋڢஶΏၺశַǎ
6. ឱၺࣱ࣌ຎพశַǎ
7. ឱӉ܅܌ᤱ᮴Աǎ߸ᜊశַឱᥗ
8. ឱӉ࠳శַ߸ᜊڛམ຺ᬅᤄ
9. ឱӉሩᬕমତ݁ڢତ݁ᄋ߸М
10. ݱؔεઑႄ຺ጴΏЦˁᜃᢇ҉
11. ឱԷΏၺԉࠓࠁᄋᬅܭ֘
12. ឱԷΏၺԉࠓ
13. ᥆ႄᭈᲟఱˁΏၺశܭ
14. ధ፦οڪᮍႁՍಬᄋ፦οցᤊ
15. శܭᤍႄ຺ʸࠁధڢ
16. ᔫႄ຺ତ݁٩Ч
17. శַᤡၺ๓
MUSIC Group IP Ltd.ОՄᄋಗญгಗǎ
© MUSIC Group IP Ltd. 2016ྡీధǎ