14 Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
FEN20 IP Address Setup
PGM-DHCP mode (600)
PGM-DHCP mode is a combination of the DHCP (400) and PGM (500) modes.
The device, when initially powered with switches set to 600, acts as DHCP client. It requests
assignment of an IP address. After the IP address is assigned, the device disables DHCP and
switches to PGM mode. Switches may be left in 600 position.
Upon power cycle, the device retains the last known IP address.
To reset PGM-DHCP mode, set rotary switches to 000 and cycle power
PROFINET mode (700)
Allows a PROFINET server to assign a PROFINET name and IP address to the device. The Turck
service tool may be used to assign device name and IP address.
RECOVERY Mode (900)
When the rotary switches are set to the RECOVERY mode (900), the device resets all device
resources to factory default values, including configuration parameters and IP address.
Set rotary switches to 900, cycle the power and wait 10 seconds
Set rotary switches to any other position and then cycle power.
To Next Page
Loading...
