Need help?Do you have a question about the turck FEN20-16DXP and is the answer not in the manual?
General| Number of Digital Inputs | 16 |
|---|---|
| Number of Digital Outputs | 16 |
| Output Type | PNP |
| Connection Technology | M12 |
| Protection Class | IP65/IP67 |
| Operating Voltage | 24 V DC |
| Input voltage | 24 V DC |
| Output current | 0.5 A |
| Number of outputs | 16 |
| Switching frequency | 100 Hz |
| Connection type | M12 |
| Protocol | EtherNet/IP |
| Operating temperature | -25°C to +70°C |
Details the steps to assign an IP address using the Turck Service Tool, including searching and entering IP details.
Guides users on assigning an IP address using Rockwell's BOOTP/DHCP server tool.
Details the procedure to configure FEN20 devices by dragging and dropping configurations from a catalog file.
Step-by-step guide for configuring FEN20 devices using a catalog file within the Logix Designer environment.
Demonstrates how to configure an FEN20 device using an EDS file within the Logix Designer.
Instructs on adding the FEN20 device to the PROFINET controller via the Navigator window and Catalog.
Explains how to assign a device name and IP address to the FEN20 device within its properties window.
Details the process of installing GSD/GSDML files into the hardware configuration using the Toolchest.
Guides on adding a PROFINET device onto the network by selecting the PROFINET Devices dropdown in the Toolchest.
To Next Page
