8 Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
FEN20 IP Address Setup
4 FEN20 IP Address Setup
All FEN20 devices support software setup of the IP address using either “Turck Service Tool” or
BOOTP/DHCP server. Additionally,
■
FEN20-16DXP has rotary switches capable of setting the IP address.
■
FEN20-4DIP-4DXP and FEN20-4DIN-4DXN stations do not have rotary switches capable of
setting the IP address.
4.1 FEN20-4DIP-4DXP
Users should set the IP address using either “Turck Service Tool” or any other IP address server
such as BOOTP/DHCP utility, to set, modify or reset the IP address of the device.
The device out of box IP address setup is:
■
IP address: 192.168.1.254
■
Netmask: 255.255.255.0
■
Gateway: 0.0.0.0
Mode of operation:
■
PGM Programmable
■
DHCP Dynamic Host Configuration Protocol
NOTE
In the PGM mode the device will reference the previous IP address at power-up, which
was assigned to the device prior to shut down. Use “Turck Service Tool” for the IP ad-
dress management.
4.2 Downloading Turck Service Tool
The Turck Service Tool can be downloaded from the Turck Website using the following link:
■
http://pdb2.Turck.de/us/DE/products/0000001a000293cb0002003a
To Next Page
Loading...
Need help?
General
