TR360 Use & Care
TR460-12/21
Page 13
( A WARN I NG )
1) Move the Fuel Valve Lever 1 to the ON position.
2) Always move the Choke Lever 2 to the Left/Closed position when
cranking starter, then move Choke lever 2 to the Right/Open position once
the engine is running.
3) Move the Throttle Lever 3 away from the MIN position to
about 1/3 of the way toward the MAX position.
4) Turn the engine switch 4 to START and hold it there until the engine
has started and allow the switch to return to the 5 ON position.
a) NEVER RUN THE STARTER FOR MORE THAN 5 SECONDS OR MOTOR DAMAGE MAY OCCUR. IF
ENGINE FAILS TO START WAIT 10 SECONDS BEFORE OPERATING THE STARTER AGAIN.
b) If using the recoil starter pull the pull cord toward you then return the pull cord gently.
c) If using the electric starter key turn the key to the START position and hold it there until the engine starts.
When the engine starts release the key, allowing it to return to the ON position.
6) If the choke lever is in the CLOSED position gradually move it to the OPEN position as the engine warms
up.
7) Set the throttle level to control the engine speed. Do not exceed 3200 RPMs.
&
8)
To move the machine:
a)
Forward - Pull the drive bar toward you.
b)
Reverse - Push the drive bar away from you.
c)
Release the drive bar to return to neutral and stop the forward/reverse motion.
MOVE THROTTLE TO THE MINIMUM POSITION TO REDUCE RPM's BEFORE TURNING OFF.
FAILURE TO DO SO WILL CAUSE CARBON TO BUILD UP ON THE ENGINE PISTON.
Turn the engine switch to the OFF position.
Turn the fuel valve lever to the OFF position (when stored)
Starting The Engine:
ALWAYS OPERATE THE DRIVE BAR SLOWLY AND GENTLY
To Next Page
Loading...