IMPORTANT
There are only 3 Grease Fittings that require WEEKLY GREASE on the T R460.
THIS IS THE SINGLE MOST IMPORTANT CARE POINT FOR YOU TO FOCUS EFFORT ON.
Grease is like
preventative medicine. Liberal use of grease and care of the machines needs will prevent major costly issues.
It is always better to over grease than under grease.
FAILURE TO GREASE THE PIVOT AND FRONT WHEEL
BEARINGS HUBS WILL RESULT IN FAILURE AND EXPENSIVE REPAIR.
We do everything possible to utilize the
best tapered bearings, seals, and other wear items to prevent wear and provide long life. Please do your part!
You can ensure years of uninterrupted life from your
TR460
by simple greasing the Front Wheel Bearing Hubs and
adjusting and greasing the Pivot Point.
IMPORTANT
Pivot Point (1 Grease Fitting)
After the first
50
Hours of use (break in
period) adjust the Pivot Point. Remove
the Cotter Pin at the base of the Pivot
Point Spindle. Tighten (CW Turn) the
Castle Nut and replace the Cotter Pin
back in the Spindle. GREASE the Pivot
Point Heavily. Repeat this as necessary
to keep tension on the Pivot Point and
reduce sloppiness from being felt in the
Operator Steering Handle Bar.
KEEP THE PIVOT POINT GREASED ON
GOING! AT LEAST WEEKLY.
Front Wheel Bearings( 1 Grease Fitting
each side of the Spreader)
Grease the Fittings on the inside of the
Front Wheel Hubs
WEEKLY!
TR460-12/21
Page 20
To Next Page
Loading...