EasyManua.ls Logo

TurMix AX 310 - 2. Operating the Appliance; Setting Up and Filling; Humidifier Operation Principles; Starting Up and Speed Adjustment

TurMix AX 310
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
23
23
DE
FR
DE
IT
GB
2. Operating the appliance
Operation
Setting up
Place on a flat, stable and waterproof surface.
Never place directly under the power socket
.
Make sure the machine stands safely and the airflow is not
blocked by e.g. furniture or curtains. Never place near cur-
tains, furniture or walls (risk of damage by moisture).
Make sure that nobody can trip over the power cable and
that the machine is out of reach of children. Never let children
play with the machine.
Important:
Only use the humidifier in dry rooms up to 50 m² / 125 m³ and without
extension cable.
Filling the water tank
Pull out the power plug.
Fill water carefully and slowly through the opening.
Note the maximum water level mark («MAX») (on the inside).
Do not exceed the maximum water capacity of 5 litres!
Caution!
Use tapwater only. Never use mineral water or softened
water! Never add salt or anythng else to the water!
Never add water through the air inlet/outlet openings!
Never put aroma essence in the water tank, only in the aroma container!
Information on evaporation type humidifiers:
The drier the room air, the more moisture is emitted by the humidifier. This
self-regulation principle prevents excessive air humidity, keeping the rela-
tive humidity between about 45 and 60 %.
For higher performance in large rooms, place the humidifier near a
radiator (max. temperature no more than 50 °C).
Air circulation strongly interferes with humidification (e.g. due to open
or loose windows in high rooms).
Please note that moisture rises with warm air and may cause
undesirable condensation.
Recommended room air humidities:
50% humidity at 18 °C room temperature
45% humidity at 20 °C room temperature
40% humidity at 22 °C room temperature
Starting up
Insert the power plug.
Turn on the power switch
(8.). The LED goes blue.
2-stage power speed selector
Select the required speed (9.):
«
» for high speed (daytime operation / blue LED display) or
«
» for low speed (nighttime operation). The respective LED display goes
green.
After use
Turn off the power switch
(8.).
Pull out the power plug.
Empty out the residual water and rinse out the water tank well.
Regularly clean and maintain the humidifier to ensure hygienic and
trouble-free operation:
Weekly: clean the housing parts.
Every 2−3 months: change the filterelements (Art. A52456 / 2 pcs;
change them earlier in case of bad odours, dirt or lime deposits and
noticeably lower humidification performance).
Let the humidifier dry out completely before storage.

Related product manuals