Turnigy TrackStar - User Manual

Turnigy TrackStar 10th Waterproof Sensored ESC Manual
Transmitter Calibration:
Connect the ESC, battery and signal line, and then press the switch button for about 3 seconds, the blue LED
long bright solid, the ESC is into the transmitter calibration mode:
1. Push the transmitter stick to maximum forward position, the blue LED will flash and then the red LED lights
will go solid.
2. Then pus
h the throttle stick to max brake position, the red LED will start flashing and then the blue and red
LED lights.
3. Return the throttle stick to neutral position, the red and blue LED will flash, then a long light for about 2
seconds, the red and blue LED light will flash twice. The transmitter calibration is complete.
Normal Operation:
Blue and Red LEDs on for Forward with pause then Reverse
Blue LED on for Forward Only
As the battery voltage gets low there is a low voltage warning. The
Red LED will blink. As Temperature gets to warning point, Blue LED
will blink.
Boos
t timing set to zero, Blue LED flashing.
Sensored alarm, the red and blue LED lights flash, ESC does not work.
Default Settings:
Operation Mode - For/Rev/Brake
Initial Braking - = Drag Brake
Drag Brake - 5%
Brake Strength - 80%
Voltage Cut Off - 3.2V/cell
Punch Profile - Level 7
Neutral DeadBand - 3%
Boost Timing - 0 deg
Reverse Speed - 75%
Drive Frequency - 8KHz
Brake Frequency - 1KHz
Temperature Set - On

Summary

Transmitter Calibration

Calibration Steps

Detailed instructions for calibrating the ESC with the transmitter, including stick movements and LED feedback.

Normal Operation

LED Indicators and Warnings

Explanation of LED states for forward/reverse, low voltage warnings, temperature alerts, and specific operational modes.

Turnigy TrackStar Specifications

General

Type	Brushless
Max Current	Varies depending on the specific motor model
Max Power	Varies depending on the specific motor model
Connector Type	Varies depending on the specific motor model
Weight	Varies depending on the specific motor model
Dimensions	Varies depending on the specific motor model
Shaft Diameter	Varies by model (e.g., 3.175mm, 5mm)
Poles	Varies by model (e.g., 2 poles, 4 poles)