Turris Omnia RTROM01-1G - Installation

USER MANUAL EN / 13
Before starting up the device, please read this manual carefully,
particularly the router installation instructions and safety information.
3× Wi-Fi
antenna*
Ethernet
cable
RouterTurrisOmnia
model: RTROM01-1G (Wi-Fi, 1 GB RAM)
model: RTROM01-2G (Wi-Fi, 2 GB RAM)
model: RTROM01-1G-NW (no Wi-Fi, 1 GB RAM)
model: RTROM01-2G-NW (no Wi-Fi, 2 GB RAM)
Power adapter,
power cable
CONTENTS
Wall mounting
bracket
User
manual
INSTALLATION
1 Connect the antennas to the connectors located on the rear panel of the router.*
2 Connect your computer and the router with the Ethernet cable.
Use one of the connectors labelled LAN0 to LAN4 on the router.
3 Plug the Ethernet cable from your modem or other device supplied by your internet
service provider into the WAN connector.
4 Plug the power cable into the router.
Important: Make sure that you are using a power adapter labelled
TurrisOmnia(12V,3,33A).
When booting up, the device gradually lights up the indicator LED's on the front
panel. This is a standard part of the start-up sequence.
5 Wait for about one minute (until the router assigns an IP address), type http://192.168.1.1
into your internet browser and follow theinstructions of the setup wizard.
The current version of the manual is always available at:
https://omnia.turris.cz/user_manual.
For questions, please use the contact form on https://omnia.turris.cz.
* Valid for Wi-Fi models only (RTROM01-1G or RTROM01-2G)