Diagnostic Mode
Surface Mode
(Low Battery)
Surface Mode
(after dive # 2)
Plan ModeFly Mode Desat Mode Log Mode Preview
(press button < 2 sec to view
Data and O2)
To Activate - press the button
The Surface Sequence scrolls through Surface Mode, Fly, Desat, and Plan mode screens.
As the Surface Sequence scrolls, the button is used to access Log and Set mode screens.
During a dive, the button is used to access Alternate displays of information.
SURFACE DISPLAYS
Main
press button to view Alt 1
Alt 1
press button to view Alt 2
Alt 2
5 sec revert to Main
Deep Stop Preview
press button 2 sec while
viewing Main
No Decompression Dive Mode
Surface Mode
(button activated)
No Deco Deep Stop
• After descending deeper than 80 FT (24 M), then ascending
to within 10 FT (3 M) below 1/2 Max Depth.
• Preview available only deeper than 1/2 Max Depth.
• Stop at 1/2 Max Depth for 2 minutes.
• No Penalty for ascending during the 2 minute countdown.
No Deco Safety Stop
• After descending deeper than 30 FT (9 M), then ascending to
20 FT (6 M).
• Stop at 15 FT (4.5 M) for 3 minutes.
• No Penalty for surfacing during the 3 minute countdown.
Safety Stop Display
press button to view other
screens
Deep Stop Display
press button to view other
screens
To Next Page
Need help?
General
