27
27
HANDLE BAR LEFT SIDE
1. Info switch
Info switch ‘ ‘ is used to cancel a incoming call, to
clear a notification on cluster display, to start / stop
the ‘LAP’ in the lap timer mode, to accept / reject the
nearest fuel location suggestion.
2. Horn switch
Press the switch ( ) to blow horn. It is used to
attract the attention of other road users in case of
danger.
IInstrument cluster’s background illumination, front
position lamps (FPL), head lamp low beam, tail lamp and
number plate lamp glow automatically once the ignition
is turned ‘ON’ without activating any other switch.
When the ignition switch is turned ‘ON’ the instrument
cluster performs self diagnostic cycle. Wait till the display
becomes static.
Note
Never attempt to move the vehicle when the steering is
locked, you may lose balance.
Before turning the ignition key to ‘ON’ position, ensure
the availability of adequate fuel in the tank to avoid dry
run of fuel pump. Fuel level always to be maintained
above single bar. Never run the fuel pump dry to avoid
failure of fuel pump.
Leaving the ignition cum steering lock in ‘ON’ position
for a prolonged time will drain the battery when the
vehicle is not in use. Switch ‘OFF’ and take the control
key out when the vehicle is not in use.
Always lock the steering while parking for safety.
Caution
4
23
5 6
1
To Next Page
Loading...
Need help?
General
