43
43
On long pressing the Mode button, the following
modes can be accessed.
1. SET mph MODE / SET km/h MODE
2. CLOCK SETTING MODE
3. BLUETOOTH PAIRING MODE
Press
MODE
button on
speedometer
Press
MODE
button on
speedometer
Press
MODE
button on
speedometer
Setting the digital display
Every press of the Mode button changes the display
to other mode. Follow the below procedures to
change the display to desired mode.
If the ignition is turned ‘OFF’ while the cluster is in
‘ODO’ or ‘TRIP’ mode, then the respective meter will
be displayed during next ignition ‘ON’. If any other
modes other than the above were set while turning
the ignition ‘OFF’, then ‘ODO’ meter will be displayed
by default during next ignition ‘ON’.
1. In ‘ODO’ mode, press the Mode button once or
twice to enter ‘ ’ and ‘ ’ meter
respectively.
• To reset any of the trip meter, while ensuring
the display is in ‘TRIP A’ or ‘TRIP B’, press and
hold the Set button for a few seconds.
2. In ‘TRIP B’ meter mode, press the Mode button
once to enter lap timer mode. On entering the
lap timer mode, a message ‘ ’
and last three laps timing will be displayed in the
cluster’s display.
• To reset the lap timer, keep the display in
‘LAP TIMER MODE’ and wait till the cluster
displays the lap timings. Now press and hold
the Set button for a few seconds.
To Next Page
Loading...
Need help?
General
