44
3. In ‘TRIP B’ meter mode, press the Mode button
twice to enter high speed mode. On entering this
mode, a message ‘ ‘ and
last achieved high speed data will be displayed in
the cluster’s display.
• To reset the high speed recorded, keep the
display in ‘HIGH SPEED MODE’, press and
hold the Set button for few a seconds.
4. In ‘TRIP B’ meter mode, press the Mode button
thrice to enter shortest time mode. On entering
this mode, last achieved shortest time ’ ‘ and
overall best time ‘ ‘ will be
displayed in the cluster’s display.
• To reset the last achieved shortest time, keep
the display in ‘SHORTEST TIME MODE’,
press and hold the Set button for few a
seconds. Please remember only last / current
record will be reset and best time display will
remain same until new best time is achieved.
5. Press the Mode button once to change the
display to ‘ODO’ mode again.
MPH and Km/h setting
1. Ensure the display is in ‘ODO’ mode.
2. Press and hold the Mode button for few seconds
till the display enters ‘ ‘. Press
the Set button to select the MPH mode.
3. To change the display to Km/h mode again, press
and hold the Mode button till the display enters
‘ ‘. Press Set button to select
the Km/h mode.
Digital clock setting
1. Ensure the display is in ‘ODO’ mode.
2. Press and hold the Mode button for few seconds
till the display enters ‘SET mph MODE’ or ‘SET
km/h MODE’ (based on preferred setting).
3. Release and short press the Mode button
once again so that the display enters
‘ ‘ mode.
If the display is set to MPH mode, it will switch to Km/h
mode by default whenever the ignition is turned ‘OFF’
and ‘ON’.
To Next Page
Loading...
Need help?
General
