29
Deactivation of ‘intelliGO’ system:
1. ‘TVS intelliGO’ system will be deactivated if the
‘MODE’ switch is positioned at ‘POWER’ mode.
2. If the ISG malfunction indicator ‘ ’ or engine
malfunction indicator ‘ ’ is ‘ON’, the intelliGO
system will not get activated.
3. If there are 5 unsuccessful start of the vehicle
either by electric start or by intelliGO restart
method the intelliGO system will not get
activated.
4. If vehicle is not restarted within 5 mins
from idle stop, then intelliGO system will be
deactivated.
5. During low battery condition the intelliGO system
will be deactivated.
Prolonged idling:
When vehicle is in idling with the engine temperature
high enough to maintain stable engine idling rpm
and the ‘Mode’ switch is in ‘ECO’ mode, then the
intelliGO system will be activated.
When ‘TVS intelliGO’ is enabled, the intelliGO lamp
blinks for predetermined time and then the engine
stops.
When the vehicle meets the above conditions,
the ‘TVS intelliGO’ system gets enabled and the
intelliGO indicator ‘ ’ in the digital speedometer
glows continuously and informs you that the vehicle
has entered intelliGO loop and the engine will stop
automatically at upcoming vehicle idling condition.
Once the vehicle enters the idling condition, the
intelliGO indicator starts blinking instead of glowing
and engine stops after predetermined time.
Now, the intelliGO indicator again starts glowing
continually during the engine stop to indicate that the
vehicle has stopped due to ‘intelliGO’ system.
‘TVS intelliGO’ system works only when the vehicle
is in ‘ECO’ mode (refer page no. 24 for details). The
vehicle, shut down by intelliGO system can be restarted
easily just by applying throttle (open and close) when the
vehicle is in neutral or by applying clutch and performing
throttle operation (open and close) when the vehicle is in
gear engaged condition.
Note
To Next Page
Loading...
