4. Remove the drain plug at the bottom of the reservoir to
drain any remaining water and then reinstall.
5. Allow the ice to fall from the evaporator, remove and
discard slab of ice. (See gures 16 and 17).
6. Determine the proper amount of cleaner from the ice
machine cleaner manufacturer’s mixture ratio based on
3
⁄4 gallon (2.81 liters) of water (refer to the manufac-
turer’s mix ratio directions). Check to be sure the reser-
voir drain plug is installed that was removed in step 4.
Add the recommended amount of concentrated clean-
ing solution to the reservoir of the ice machine. This can
be done by pouring the solution on the evaporator,
which will ow down into the reservoir. (See gure 18).
7. Switch the selector switch on the grille of the ice ma-
chine to the “CLEAN” position. The ice machine will
automatically start and stop the cleaning cycle and ¾ of
a gallon (2.81 liters) of water will automatically be
added to the cleaning solution.
8. The total cleaning time will end in 49 minutes. The
cleaning cycle will automatically rinse the evaporator
plate and also drain the cleaning solution and rinse the
reservoir with water.
9. After the cleaning cycle has ended check that the build-
up has been removed. The evaporator plate should be
clean, shiny, and smooth to the touch. If build-up is still
visible, repeat the cleaning cycle above.
10. Clean the ice machine’s interior, ice scoop, interior door
panel and door gasket with mild soap and water. Using
two (2) tablespoons of baking soda in one (1) quart of
warm water while cleaning will help remove odors.
Rinse with fresh water.
DO NOT USE ANY ABRASIVE CLEANING PROD-
UCTS.
11. Replace the front panel.
12. Your ice machine is now clean and sanitized and may
be put back into operation by switching the selector
switch to the “ON” position.
Drain plug
in bottom of
reservoir.
Figure 15
Figure 18
Discard the rst batch of ice.
In the unlikely event a power interrupt occurs during the
clean cycle, you need to start over from the beginning to
assure complete cleaning and rinsing of the cleaning agent
from the machine.
11
OPERATION, CARE, AND CLEANING OF YOUR ICE MACHINE
Figure 16
Allow ice slab
to fall on to
grid cutter
Figure 17
Remove ice
slab and
discard
To Next Page
Loading...