TWO TREES SK1 - Accessories List; Assembly Instructions; Remove the Z-axis Fixation; Remove the XY Axis Fixings

7
Print File Format
G-code
Supported System
MacOS/Windows/Linux
Hot Bed Temperature (Max)
100°C
Working Enviroment
Temperature 5-40°C, humidity 20-60% RH
Accessories List
Machine
Accessory Box
Half Round Head Screw M3×6X2
Half Round Head Screw M4×8X2
Filament Rack
Screen Holder
Screen
Assembly Instructions
Remove the Z-axis Fixation
• Use cup head screws M3×62.
Note: Remove the top wire setting screws. After removal, reinstall the firmware and lock
back the screws, using cup head screws M3*6 on both sides.
Remove the XY Axis Fixings
Install the Filament Rack
• Use half-round head screws M4×8X2.
• Filament rack X1.
Install the 4.3inch Screen Module
• Install the Screen holder X1.
• Use half-round head screws M3×6X2. b. Before installation, insert the reserved
screen cable into the terminal block, and then push the screen assembly along
the chute into the corresponding slot of the bracket. The installation is now
complete.