Tyco CIM800 - Page 5

Associated equipment MZX CIM800
Installation Instructions Doc. version 4.0 5/8
Fig. 7: Spur Circuits (Class B) Normally Closed Contacts
Short Circuit A+ to A- or B+ to B = Fault
1 – MX Controller
2 – To next device
3 – Programming port
+VE
-VE
TB1
TB2
A+ A- B+ B-
L+ L- L+ L-
100
200
100
200
1
2
3
NOTICE
 If only one circuit is used the user circuit
must be terminated with 200 ohm
EOL resistor.
 MX CONSYS configuration selection –
style C (normally open)
 Mode 2