Document No: LT0122 F3200 Installation & Programming Manual
Programming
Issue 2.7 5 July 2001 Page 6-3
GENERAL (CONTINUED)
If "CLEAR ESC" is pressed enough times, the programming mode display is exited and the
database checksum is calculated.
FIG 6.1.1
MENU STRUCTURE
Details of the programming menu are shown in Figures 6.1.2A-C.
Figure 6.1.2A is for V1.00 and V1.01 software
Figure 6.1.2B is for V1.10 software
Figure 6.1.2C is for V2.0X software, noting that some commands are only available from
specific versions onwards.
Fig 6.1.2C and 6.1.2D1/D2 are for V2.0X software but note that some options are not
provided in “older” software versions.
BASE DISPLAY
PRESS “SET” KEY
TO ENTER
To Next Page
Loading...
