33User guide Doc. version 1.2
7 Extended telephone functions
VL Telephone/VL Telephone plus
7.11 Room monitoring
You can monitor a room where your telephone is located -
remotely.
The function ”room monitoring” has to be activated at the
telephone in the room to be monitored (see page 52 of
”commissioning and programming“.
Tone dialling must be set at the telephone from which you
intend to monitor the room. Pick-up the handset, dial the
telephone number. The telephone in the room to be
monitored rings once and connects the line. After this enter
the four-digit access code (see page 52 of the programming
instructions). Afterwards, the device switches to the
monitoring mode and you can listen to what is happening in
the surroundings, i. e. monitor the room. If you wish to have
a ”silent monitoring” without the earlier ringing signal, you
just need to deactivate the ringing signal (see page 57 of
”commissioning and programming“.
You can switch from the monitoring mode to a ”two-way
communication“ by pressing the following numeric keys:
The telephone switches to hands-free mode.
Two-way-communication: You hear the person
in the monitored room.
Two-way-communication: You speak.
You can switch back and forth by pressing the
keys 4 and 6.
”Replace the handset”. The connection is
disconnected. In the monitored room, no busy
tones are heard via the loudspeaker.
To Next Page
Loading...