PTO monitor Lamp
■ The PTO monitor lamp on the dash panel indicates the state of the PTO shaft.
1. If the monitor glows: The PTO is rotating
2. If the monitor is off: The PTO is off
3. If the monitor blinks: The PTO is presently stationary but will instantly start
rotating of the clutch pedal is released or the implement is lowered.
1.When the PTO control switch is in manual position the PTO does
not stop rotating even if the clutch pedal is pressed. If working on hard soils,
pavements with a rotary implement the PTO ON/OFF switch must be put to the
OFF position to stop the PTO from rotating , If this is not done the rotating blades
of the implement will push on the hard ground below and in turn push the tractor
toward causing accident which can lead to serious injuries or death.
2. Extra precaution must be taken to clear the area of bystanders/onlookers when
using PTO driven 0implements. The rotating blades of the implements can cause
serious injuries on contact. The warning that is indicated by the blinking PTO
monitor is to make the operator aware that the PTO is in on position and will
instantly start rotating if the clutch pedal is released or implement is lowered or
Warning
45
Always use the clutch when engaging or disengaging the PTO or changing PTO
speed. Let the PTO driven implement come to a complete stop before changing.
Important
Caution
Do not operate any implement at a high speed than is specified for it.
When making adjustments to the implement stop the engine to avoid serious injury.
When leaving the tractor stop the engine, and remove the key. Set the parking brake.
3.In no case the specified rotating speeds indicated by the implement manufacturer
be crossed as the same can lead to serious damage to the tractor/equipment and can
lead to serious injuries to persons around.
To Next Page
Loading...
