►
►►
► PTO GEAR SELECTION LEVER
Your tractor is equipped with 3 Speed PTO to suit range of
applications and conditions.
MODEL
POSITION
1st 2nd 3rd
T1003/T903/T803 540 1000 750
■
■■
■ When Selecting the PTO Speed
① First, Pull up the PTO ON/OFF switch and Select the
PTO Speed as required. (540rpm, 750rpm, 1000rpm)
② Second, Push down the PTO ON/OFF switch and Use to operate
with Implements.
►
►►
► INDEPENDENT PTO
■ It must be noted that the PTO shift lever on the LHS below the driver seat should be shifted to position
1 (540 rpm), 2 (1000rpm) or 3 (750rpm) depending upon the implement specification.
In no case the specified speeds be crossed as serious damage to the tractor/implement to person can
When the PTO is not in use the shift lever must be put in neutral position to avoid
When the PTO is not in use the shift lever must be put in neutral position to avoid
unnecessary use or accidental use.
Hydraulic fluid escaping under pressure can have enough force to penetrate the skin.
Hydraulic fluid may also infect a minor cut or opening in the skin. If injured by
escaping fluid. See a doctor at once. Serious infection or reaction can result if
medical treatment is not given immediately. Make sure all connections are tight and
that hoses and lines are in good condition before applying pressure to the system.
Release all pressure before disconnecting the lines or performing other work on the
hydraulic system. To find a leak under pressure use a small piece of cardboard or
wood. Never use hands.
Warning
■ PTO ON/OFF switch (MANUAL)
PTO ON/OFF switch is located on the right side of the
Lever/Switch panel .
When the switch is pull up to start the PTO indicator
glows to indicate that the switch and the PTO are in ON
position, If the switch is pushed down the indicator
goes off signaling that the PTO is OFF.
To Next Page
Loading...
