6-12
7) Remove the stop ring and the wheel shaft can
be extracted.
Fig.6-21
Fig.6-22
8) Remove the seal from the wheel shaft cover
Fig.6-23
9) Remove the cap (11) from the bottom of the
final case B and detach the snap ring(hole).
Then the counter shaft(8) and BRG can be
removed.
Note:
The removed cap(55) (black plug) should be
discarded and replaced when reassembled.
3.2 INSPECTION
1) Wheel shaft cover
- Inspect mechanical oil seal, O-rings, Gears,
cases, etc. and replace them if worn or damaged.
-Measure the diameter the part which makes
contact with the wheel shaft, with a micro-meter
or vernier-calipers. When the measured value
less than the usable limit, replace the wheel shaft
cover.
Standard value 72
Usable limit 72.05
2) Final Drive case (B)
-Measure the diameter the part which makes
contact with the Final drive case (A), with a
micro-meter or vernier-calipers. When the
measured value less than the usable limit,
replace the wheel shaft cover.
Standard value 75
Usable limit 75.05
Fig.6-25
Fig.6-24
To Next Page
Loading...
