TYM T264 - Page 145

7-6
Fig.7-9
Apply force only to the shaded parts
Take care not to deform these portions
5) press the wheel shaft.
6) Install the wheel gear, the bearing, and snap ring
on the wheel shaft and retain them.
7) Install the brake metal, the steel ball and the
return spring
8) Install the friction plate, brake plate and the
brake cover
Note :
When installing the brake disc, Disc plate and
separator should be arranged in correct order.
Apply an grease to the oil seal and take care not to
be damaged when installing to the brake cam.
Pay particular attention to the installation of the
snap ring.
The assembled wheel pinion should rotate smoothly.
7) Apply adhesive (THREE BOND 1215) to the
contact surfaces of the rear housing and rear
transmission case and then reassemble the rear
housing by tightening the bolts to the specified
torque.
Tightening torque 4.5-6.0 Kgf.m
4) Replace the oil seal.
Install the bearing and the snap ring into the axle housing, and then press in the oil seal by applying
force only to the circumference as shown in the figure( Fig.7-9)