1-2. REASSEMBLY
Reassemble them in reverse order of disassembly in accordance with the following instruction.
- Installation of coupling PTO and related parts.
(1) When installing the coupling PTO on the flywheel, be sure to install the bolts to flywheel.
(2) Apply a thin coat of molybdenum disulfide-based grease(Three bond TB1901 or equivalent) to
revolving or sliding parts prior to reassembly.
(3) When installing the coupling PTO on the flywheel, take care not to damage this clutch damper.
(4) Apply an ANTI RUST 720S or equivalent after installing clutch damper in order to prevent
from rust.
5-5
Fig.5-5
Apply adhesive(TB1901)
Apply adhesive(TB1215)
HST Unit-Rear Case
To Next Page
Loading...
