When changing from forward to reverse or back to forward again while in high
range make sure the tractor comes to a stop before changing direction. Failure to do
so is likely to result in damage to the mechanism and place the driver at risk of
injury.
Important
Operate the shuttle shift only while seated on the tractor.
Do not use the shuttle shift lever to start the tractor for towing or traveling uphill,
use the clutch instead.
Always stop the tractor before getting off.
►
►►
► MAIN SHIFT LEVER
The Main gear lever is composed of 4 gears with
2 Power Shift Switches.
■
■■
■ Power Shift Switch (If equipped)
Press the Button ①
①①
① or ②
②②
② to select the speed
without Using the Clutch pedal.
①
①①
① button – High Speed
Warning
41
②
②②
② button – Low Speed
►
►►
► SUB SHIFT LEVER (Range Shift Lever)
The range shift lever is used to select the speed
range of the machine and has Four range gears.
T803 – 16 Forward, 16 Reverse
T903, T1003 – 32 Forward, 32 Reverse
Avoid damage!
Select the proper speed range and gear for the job.
• The machine maybe operated in any gear with engine speeds at 700-2400 rpm.
Within these limits, the engine can be placed under varying load operations.
• Never overload engine by lugging machine at low idle speeds.
• Raise engine speed the match expected loads. If a slight increase engine rpm occurs
simultaneously with moving hand throttle lever forward, the engine is not
overloaded.
Important
* SUB SHIFT LEVER* MAIN SHIFT LEVER
Power Shift Switch
To Next Page
Loading...
